[Title 40 CFR 60.166]
[Code of Federal Regulations (annual edition) - July 1, 2009 Edition]
[Title 40 - PROTECTION OF ENVIRONMENT]
[Chapter I - ENVIRONMENTAL PROTECTION AGENCY (CONTINUED)]
[Subchapter C - AIR PROGRAMS (CONTINUED)]
[Part 60 - STANDARDS OF PERFORMANCE FOR NEW STATIONARY SOURCES--]
[Subpart P - Standards of Performance for Primary Copper Smelters]
[Sec. 60.166 - Test methods and procedures.]
[From the U.S. Government Printing Office]


40PROTECTION OF ENVIRONMENT62009-07-012009-07-01false60.166Sec. 60.166PROTECTION OF ENVIRONMENTENVIRONMENTAL PROTECTION AGENCY (CONTINUED)AIR PROGRAMS (CONTINUED)STANDARDS OF PERFORMANCE FOR NEW STATIONARY SOURCES--Standards of Performance for Primary Copper Smelters
Sec. 60.166  Test methods and procedures.

    (a) In conducting performance tests required in Sec. 60.8, the 
owner or operator shall use as reference methods and procedures the test 
methods in appendix A of this part or other methods and procedures as 
specified in this section, except as provided in Sec. 60.8(b).
    (b) The owner or operator shall determine compliance with the 
particulate matter, sulfur dioxide (SO2) and visible emission 
standards in Sec. Sec. 60.162, 60.163, and 60.164 as follows:
    (1) Method 5 shall be used to determine the particulate matter 
concentration. The sampling time and sample volume for each run shall be 
at least 60 minutes and 0.85 dscm (30 dscf).
    (2) The continuous monitoring system of Sec. 60.165(b)(2) shall be 
used to determine the SO2 concentrations on a dry basis. The 
sampling time for each run shall be 6 hours, and the average 
SO2 concentration shall be computed for the 6-hour period as 
in Sec. 60.165(c). The monitoring system drift during the run may not 
exceed 2 percent of the span value.
    (3) Method 9 and the procedures in Sec. 60.11 shall be used to 
determine opacity.

[54 FR 6668, Feb. 14, 1989]