[Federal Register Volume 75, Number 5 (Friday, January 8, 2010)]
[Notices]
[Pages 1053-1054]
From the Federal Register Online via the Government Printing Office [www.gpo.gov]
[FR Doc No: 2010-148]
-----------------------------------------------------------------------
ENVIRONMENTAL PROTECTION AGENCY
[EPA-HQ-OECA-2009-0417; FRL-9101-4]
Agency Information Collection Activities; Submission to OMB for
Review and Approval; Comment Request; NSPS for Surface Coating of
Plastic Parts for Business Machines, EPA ICR Number 1093.09, OMB
Control Number 2060-0162
AGENCY: Environmental Protection Agency (EPA).
ACTION: Notice.
-----------------------------------------------------------------------
SUMMARY: In compliance with the Paperwork Reduction Act (44 U.S.C. 3501
et seq.), this document announces that an Information Collection
Request (ICR) has been forwarded to the Office of Management and Budget
(OMB) for review and approval. This is a request to renew an existing
approved collection. The ICR which is abstracted below describes the
nature of the collection and the estimated burden and cost.
DATES: Additional comments may be submitted on or before February 8,
2010.
ADDRESSES: Submit your comments, referencing docket ID number EPA-HQ-
OECA-2009-0417, to (1) EPA online using www.regulations.gov (our
preferred method), or by e-mail to docket.oeca@epa.gov, or by mail to:
EPA Docket Center (EPA/DC), Environmental Protection Agency,
Enforcement and Compliance Docket and Information Center, mail code
2801T, 1200 Pennsylvania Avenue, NW., Washington, DC 20460, and (2) OMB
at: Office of Information and Regulatory Affairs, Office of Management
and
[[Page 1054]]
Budget (OMB), Attention: Desk Officer for EPA, 725 17th Street, NW.,
Washington, DC 20503.
FOR FURTHER INFORMATION CONTACT: John Schaefer, Office of Air Quality
Planning and Standards, Sector Policies and Programs Division (D243-
05), Measurement Policy Group, Environmental Protection Agency,
Research Triangle Park, North Carolina, 27711; telephone number: (919)
541-0296; fax number: (919) 541-3207; e-mail address:
schaefer.john@epa.gov.
SUPPLEMENTARY INFORMATION: EPA has submitted the following ICR to OMB
for review and approval according to the procedures prescribed in 5 CFR
1320.12. On July 8, 2009 (74 FR 32580), EPA sought comments on this ICR
pursuant to 5 CFR 1320.8(d). EPA received no comments. Any additional
comments on this ICR should be submitted to EPA and OMB within 30 days
of this notice.
EPA has established a public docket for this ICR under docket ID
number EPA-HQ-OECA-2009-0417, which is available for public viewing
online at http://www.regulations.gov, in person viewing at the
Enforcement and Compliance Docket in the EPA Docket Center (EPA/DC),
EPA West, Room 3334, 1301 Constitution Avenue, NW., Washington, DC. The
EPA Docket Center Public Reading Room is open from 8:30 a.m. to 4:30
p.m., Monday through Friday, excluding legal holidays. The telephone
number for the Reading Room is (202) 566-1744, and the telephone number
for the Enforcement and Compliance Docket is (202) 566-1752.
Use EPA's electronic docket and comment system at http://www.regulations.gov, to submit or view public comments, access the
index listing of the contents of the docket, and to access those
documents in the docket that are available electronically. Once in the
system, select ``docket search,'' then key in the docket ID number
identified above. Please note that EPA's policy is that public
comments, whether submitted electronically or in paper, will be made
available for public viewing at http://www.regulations.gov, as EPA
receives them and without change, unless the comment contains
copyrighted material, confidential business information (CBI), or other
information whose public disclosure is restricted by statute. For
further information about the electronic docket, go to
www.regulations.gov.
Title: NSPS for Surface Coating of Plastic Parts for Business
Machines
ICR Numbers: EPA ICR Number 1093.09, OMB Control Number 2060-0162.
ICR Status: This ICR is scheduled to expire on January 31, 2010.
Under OMB regulations, the Agency may continue to conduct or sponsor
the collection of information while this submission is pending at OMB.
An Agency may not conduct or sponsor, and a person is not required to
respond to, a collection of information unless it displays a currently
valid OMB control number. The OMB control numbers for EPA's regulations
in title 40 of the CFR, after appearing in the Federal Register when
approved, are listed in 40 CFR part 9, and displayed either by
publication in the Federal Register or by other appropriate means, such
as on the related collection instrument or form, if applicable. The
display of OMB control numbers in certain EPA regulations is
consolidated in 40 CFR part 9.
Abstract: The New Source Performance Standards (NSPS) for Surface
Coating of Plastic Parts for Business Machines were promulgated on
January 29, 1988. These standards apply to each spray booth that
applies prime coats, color coats, texture coats or touch-up coats in
industrial surface coating operations that apply coatings to plastic
parts for use in the manufacture of business machines.
Affected sources are required to complete initial notifications,
performance tests, and periodic reports. Owners or operators are also
required to maintain records of the occurrence and duration of any
startup, shutdown, or malfunction in the operation of an affected
facility, or any period during which the monitoring system is
inoperative. These notifications, reports, and records are essential in
determining compliance; and are required, in general, of all sources
subject to NSPS.
Burden Statement: The annual public reporting and recordkeeping
burden for this collection of information is estimated to average 35
hours per response. Burden means the total time, effort, or financial
resources expended by persons to generate, maintain, retain, or
disclose or provide information to or for a Federal agency. This
includes the time needed to review instructions; develop, acquire,
install, and utilize technology and systems for the purposes of
collecting, validating, and verifying information, processing and
maintaining information, and disclosing and providing information;
adjust the existing ways to comply with any previously applicable
instructions and requirements which have subsequently changed; train
personnel to be able to respond to a collection of information; search
data sources; complete and review the collection of information; and
transmit or otherwise disclose the information.
Respondents/Affected Entities: Business machine manufacturers.
Estimated Number of Respondents: 10.
Frequency of Response: Initially, quarterly, and semiannually.
Estimated Total Annual Hour Burden: 978.
Estimated Total Annual Cost: $92,296 in labor costs and $0 in
capital/startup costs or operation and maintenance (O&M) costs.
Changes in the Estimates: There is a decrease estimated burden
currently identified in the OMB Inventory of Approved ICR Burdens. This
decrease was due to a change in the adjustments to the estimates to
correct a mathematical error.
Dated: December 24, 2009.
Richard T. Westlund,
Acting Director, Collection Strategies Division.
[FR Doc. 2010-148 Filed 1-7-10; 8:45 am]
BILLING CODE 6560-50-P