Federal Register, Volume 75 Issue 8 (Wednesday, January 13, 2010)

[Federal Register Volume 75, Number 8 (Wednesday, January 13, 2010)]
[Rules and Regulations]
[Pages 1697-1699]
From the Federal Register Online via the Government Printing Office [www.gpo.gov]
[FR Doc No: 2010-103]

=======================================================================
-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2009-1252; Directorate Identifier 2009-NM-248-AD;
Amendment 39-16173; AD 2010-02-02]
RIN 2120-AA64

Airworthiness Directives; Dassault-Aviation Model Falcon 7X
Airplanes

AGENCY: Federal Aviation Administration (FAA), Department of
Transportation (DOT).

ACTION: Final rule; request for comments.

-----------------------------------------------------------------------

SUMMARY: We are adopting a new airworthiness directive (AD) for the
products listed above. This AD results from mandatory continuing
airworthiness information (MCAI) originated by an aviation authority of
another country to identify and correct an unsafe condition on an
aviation product. The MCAI describes the unsafe condition as:

DATES: This AD becomes effective January 28, 2010.
We must receive comments on this AD by March 1, 2010.

ADDRESSES: You may send comments by any of the following methods:
Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
Fax: (202) 493-2251.
Mail: U.S. Department of Transportation, Docket
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New
Jersey Avenue, SE., Washington, DC 20590.

[[Page 1698]]

Hand Delivery: U.S. Department of Transportation, Docket
Operations, M-30, West Building Ground Floor, Room W12-40, 1200 New
Jersey Avenue, SE., Washington, DC, between 9 a.m. and 5 p.m., Monday
through Friday, except Federal holidays.

Examining the AD Docket

You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations office
between 9 a.m. and 5 p.m., Monday through Friday, except Federal
holidays. The AD docket contains this AD, the regulatory evaluation,
any comments received, and other information. The street address for
the Docket Operations office (telephone (800) 647-5527) is in the
ADDRESSES section. Comments will be available in the AD docket shortly
after receipt.

FOR FURTHER INFORMATION CONTACT: Tom Rodriguez, Aerospace Engineer,
International Branch, ANM-116, Transport Airplane Directorate, FAA,
1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425)
227-1137; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION:

Discussion

The European Aviation Safety Agency (EASA), which is the Technical
Agent for the Member States of the European Community, has issued EASA
Airworthiness Directive 2009-0208, dated October 13, 2009 (referred to
after this as ``the MCAI''), to correct an unsafe condition for the
specified products. The MCAI states:

Several occurrences of untimely radio-altimeter lock-up have
been reported, where the failed radio-altimeter indicated a negative
distance to the ground despite the aircraft was flying at medium or
high altitude.
A locked radio-altimeter 1 leads to untimely inhibition
of warnings that could be displayed along with certain abnormal
conditions while the avionic system switches into landing mode
during altitude cruise.
Investigation in order to determine the root cause of radio-
altimeter lock-up is in progress. In the meantime, Dassault Aviation
has developed an operational procedure that in case of radio-
altimeter 1 lock-up allows the crew, by depowering radio-
altimeter 1, to restore in flight the system warning
performance.
Failure to comply with this interim flight procedure may cause
the crew to be unaware of possible system failures that could
require urgent crew's actions.
This AD mandates application of a new abnormal Airplane Flight
Manual (AFM) procedure when radio-altimeter 1 lock-up
occurs and prohibits dispatch of the aeroplane with any radio-
altimeter inoperative.

You may obtain further information by examining the MCAI in the AD
docket.

FAA's Determination and Requirements of This AD

This product has been approved by the aviation authority of another
country, and is approved for operation in the United States. Pursuant
to our bilateral agreement with the State of Design Authority, we have
been notified of the unsafe condition described in the MCAI and service
information referenced above. We are issuing this AD because we
evaluated all pertinent information and determined the unsafe condition
exists and is likely to exist or develop on other products of the same
type design.

Differences Between the AD and the MCAI or Service Information

We have reviewed the MCAI and related service information and, in
general, agree with their substance. But we might have found it
necessary to use different words from those in the MCAI to ensure the
AD is clear for U.S. operators and is enforceable. In making these
changes, we do not intend to differ substantively from the information
provided in the MCAI and related service information.
We might also have required different actions in this AD from those
in the MCAI in order to follow FAA policies. Any such differences are
highlighted in a NOTE within the AD.

FAA's Determination of the Effective Date

An unsafe condition exists that requires the immediate adoption of
this AD. The FAA has found that the risk to the flying public justifies
waiving notice and comment prior to adoption of this rule because lock-
up of the radio-altimeter could interfere with critical flight system
annunciations and functions, which could cause the flightcrew to be
unaware of possible system failures that could require urgent
flightcrew actions. Therefore, we determined that notice and
opportunity for public comment before issuing this AD are impracticable
and that good cause exists for making this amendment effective in fewer
than 30 days.

Comments Invited

This AD is a final rule that involves requirements affecting flight
safety, and we did not precede it by notice and opportunity for public
comment. We invite you to send any written relevant data, views, or
arguments about this AD. Send your comments to an address listed under
the ADDRESSES section. Include ``Docket No. FAA-2009-1252; Directorate
Identifier 2009-NM-248-AD'' at the beginning of your comments. We
specifically invite comments on the overall regulatory, economic,
environmental, and energy aspects of this AD. We will consider all
comments received by the closing date and may amend this AD because of
those comments.
We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We
will also post a report summarizing each substantive verbal contact we
receive about this AD.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to
issue rules on aviation safety. Subtitle I, section 106, describes the
authority of the FAA Administrator. ``Subtitle VII: Aviation
Programs,'' describes in more detail the scope of the Agency's
authority.
We are issuing this rulemaking under the authority described in
``Subtitle VII, Part A, Subpart III, Section 44701: General
requirements.'' Under that section, Congress charges the FAA with
promoting safe flight of civil aircraft in air commerce by prescribing
regulations for practices, methods, and procedures the Administrator
finds necessary for safety in air commerce. This regulation is within
the scope of that authority because it addresses an unsafe condition
that is likely to exist or develop on products identified in this
rulemaking action.

Regulatory Findings

We determined that this AD will not have federalism implications
under Executive Order 13132. This AD will not have a substantial direct
effect on the States, on the relationship between the national
government and the States, or on the distribution of power and
responsibilities among the various levels of government.
For the reasons discussed above, I certify this AD:
1. Is not a ``significant regulatory action'' under Executive Order
12866;
2. Is not a ``significant rule'' under the DOT Regulatory Policies
and Procedures (44 FR 11034, February 26, 1979); and
3. Will not have a significant economic impact, positive or
negative, on a substantial number of small entities under the criteria
of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to
comply with this AD and placed it in the AD docket.

[[Page 1699]]

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Safety.

Adoption of the Amendment

0
Accordingly, under the authority delegated to me by the Administrator,
the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0
1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended]

0
2. The FAA amends Sec. 39.13 by adding the following new AD:

2010-02-02 Dassault-Aviation: Amendment 39-16173. Docket No. FAA-
2009-1252; Directorate Identifier 2009-NM-248-AD.

Effective Date

(a) This airworthiness directive (AD) becomes effective January
28, 2010.

Affected ADs

(b) None.

Applicability

Subject

(d) Air Transport Association (ATA) of America Code 34:
Navigation.

Reason

(e) The mandatory continued airworthiness information (MCAI)
states:
Several occurrences of untimely radio-altimeter lock-up have
been reported, where the failed radio-altimeter indicated a negative
distance to the ground despite the aircraft was flying at medium or
high altitude.
A locked radio-altimeter 1 leads to untimely inhibition
of warnings that could be displayed along with certain abnormal
conditions while the avionic system switches into landing mode
during altitude cruise.
Investigation in order to determine the root cause of radio-
altimeter lock-up is in progress. In the meantime, Dassault Aviation
has developed an operational procedure that in case of radio-
altimeter 1 lock-up allows the crew, by depowering radio-
altimeter 1, to restore in flight the system warning
performance.
Failure to comply with this interim flight procedure may cause
the crew to be unaware of possible system failures that could
require urgent crew's actions.
This AD mandates application of a new abnormal Airplane Flight
Manual (AFM) procedure when radio-altimeter 1 lock-up
occurs and prohibits dispatch of the aeroplane with any radio-
altimeter inoperative.

Compliance

(f) You are responsible for having the actions required by this
AD performed within the compliance times specified, unless the
actions have already been done.

Actions

(g) Within 14 days after the effective date of this AD: Revise
the Limitations Section of the Dassault Falcon 7X Airplane Flight
Manual (AFM) to include the following statement. This may be done by
inserting a copy of this AD in the AFM.
``If radio-altimeter 1 lock-up conditions occur in
flight, power off radio-altimeter 1, in accordance with the
instructions of Falcon 7X AFM procedure 3-140-65.
Dispatch of the airplane with any radio-altimeter inoperative is
prohibited.''

Note 1: When a statement identical to that in paragraph (g) of
this AD has been included in the general revisions of the AFM, the
general revisions may be inserted into the AFM, and the copy of this
AD may be removed from the AFM.

FAA AD Differences

Note 2: This AD differs from the MCAI and/or service information
as follows: No differences.

Other FAA AD Provisions

(h) The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager,
International Branch, ANM-116, Transport Airplane Directorate, FAA,
has the authority to approve AMOCs for this AD, if requested using
the procedures found in 14 CFR 39.19. Send information to ATTN: Tom
Rodriguez, Aerospace Engineer, International Branch, ANM-116,
Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton,
Washington 98057-3356; telephone (425) 227-1137; fax (425) 227-1149.
Before using any approved AMOC on any airplane to which the AMOC
applies, notify your principal maintenance inspector (PMI) or
principal avionics inspector (PAI), as appropriate, or lacking a
principal inspector, your local Flight Standards District Office.
The AMOC approval letter must specifically reference this AD.
(2) Airworthy Product: For any requirement in this AD to obtain
corrective actions from a manufacturer or other source, use these
actions if they are FAA-approved. Corrective actions are considered
FAA-approved if they are approved by the State of Design Authority
(or their delegated agent). You are required to assure the product
is airworthy before it is returned to service.
(3) Reporting Requirements: For any reporting requirement in
this AD, under the provisions of the Paperwork Reduction Act (44
U.S.C. 3501 et seq.), the Office of Management and Budget (OMB) has
approved the information collection requirements and has assigned
OMB Control Number 2120-0056.

Related Information

(i) Refer to MCAI EASA Airworthiness Directive 2009-0208, dated
October 13, 2009, for related information.

Material Incorporated by Reference

(j) None.

Issued in Renton, Washington, on December 28, 2009.
Ali Bahrami,
Manager, Transport Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 2010-103 Filed 1-12-10; 8:45 am]
BILLING CODE 4910-13-P