[Federal Register Volume 76, Number 68 (Friday, April 8, 2011)] [Notices] [Pages 19767-19768] From the Federal Register Online via the Government Publishing Office [www.gpo.gov] [FR Doc No: 2011-8426] ----------------------------------------------------------------------- ENVIRONMENTAL PROTECTION AGENCY [EPA-HQ-OECA-2010-0372; FRL-9292-2] Agency Information Collection Activities; Submission to OMB for Review and Approval; Comment Request; NESHAP for Epoxy Resin and Non- Nylon Polyamide Production (Renewal) AGENCY: Environmental Protection Agency (EPA). ACTION: Notice. ----------------------------------------------------------------------- SUMMARY: In compliance with the Paperwork Reduction Act (44 U.S.C. 3501 et seq.), this document announces that an Information Collection Request (ICR) has been forwarded to the Office of Management and Budget (OMB) for review and approval. This is a request to renew an existing approved collection. The ICR which is abstracted below describes the nature of the collection and the estimated burden and cost. DATES: Additional comments may be submitted on or before May 9, 2011. ADDRESSES: Submit your comments, referencing docket ID number EPA-HQ- OECA-2010-0372 to (1) EPA online using http://www.regulations.gov (our preferred method), or by e-mail to [email protected], or by mail to: EPA Docket Center (EPA/DC), Environmental Protection Agency, Enforcement and Compliance Docket and Information Center, Mail Code 28221T, 1200 Pennsylvania Avenue, NW., Washington, DC 20460, and (2) OMB at: Office of Information and Regulatory Affairs, Office of Management and Budget (OMB), Attention: Desk Officer for EPA, 725 17th Street, NW., Washington, DC 20503. FOR FURTHER INFORMATION CONTACT: Learia Williams, Office of Compliance, Mail Code 2223A, Environmental Protection Agency, 1200 Pennsylvania Avenue, NW., Washington, DC 20460; telephone number: (202) 564-4113; fax number: (202) 564-0050; e-mail address: [email protected]. SUPPLEMENTARY INFORMATION: EPA has submitted the following ICR to OMB for review and approval according to the procedures prescribed in 5 CFR 1320.12. On June 2, 2010 (75 FR 30813), EPA sought comments on this ICR pursuant to 5 CFR 1320.8(d). EPA received no comments. Any additional comments on this ICR should be submitted to EPA and OMB within 30 days of this notice. EPA has established a public docket for this ICR under docket ID number EPA-HQ-OECA-2010-0372, which is available for public viewing online at [[Page 19768]] http://www.regulations.gov, or in person viewing at the Enforcement and Compliance Docket in the EPA Docket Center (EPA/DC), EPA West, Room 3334, 1301 Constitution Avenue, NW., Washington, DC. The EPA Docket Center Public Reading Room is open from 8:30 a.m. to 4:30 p.m., Monday through Friday, excluding legal holidays. The telephone number for the Reading Room is (202) 566-1744, and the telephone number for the Enforcement and Compliance Docket is (202) 566-1752. Use EPA's electronic docket and comment system at http://www.regulations.gov either to submit or view public comments, access the index listing of the contents of the docket, and to access those documents, whether submitted electronically or in paper will be made available for public viewing at http://www.regulations.gov as EPA receives them and without change, unless the comment contains copyrighted material, Confidential Business Information (CBI), or other information whose public disclosure is restricted by statute. For further information about in the docket that are available electronically. Once in the system, select ``docket search,'' then key in the docket ID number identified above. Please note that EPA's policy is that public comments the electronic docket, go to http://www.regulations.gov. Title: NESHAP for Epoxy Resin and Non-Nylon Polyamide Production (Renewal). ICR Numbers: EPA ICR Number 1681.07, OMB Control Number 2060-0290. ICR Status: This ICR is scheduled to expire on May 31, 2011. Under OMB regulations, the Agency may continue to conduct or sponsor the collection of information while this submission is pending at OMB. An agency may not conduct or sponsor, and a person is not required to respond to, a collection of information unless it displays a currently valid OMB control number. The OMB control numbers for EPA's regulations in title 40 of the CFR, after appearing in the Federal Register when approved, are listed in 40 CFR part 9, and displayed either by publication in the Federal Register or by other appropriate means, such as on the related collection instrument or form, if applicable. The display of OMB control numbers in certain EPA regulations is consolidated in 40 CFR part 9. Abstract: The National Emission Standards for Hazardous Air Pollutants (NESHAP) for Epoxy Resin and Non-Nylon Polyamide Production were proposed on May 16, 1994, and promulgated on March 8, 1995. This ICR contains recordkeeping and reporting requirements that are mandatory for compliance with 40 CFR part 63, subpart W, regulating hazardous air pollutants from process vents, storage vessels, wastewater systems and equipment leaks. The standards require mandatory recordkeeping and reporting to document process information related to the source's ability to comply with the standards. This information is used by the Agency to identify sources subject to the standards and to insure that the maximum achievable control technology is being properly applied. Section 112 of the Clean Air Act, as amended in 1990, requires that EPA establish standards to limit emissions of hazardous air pollutants (HAPs) from stationary sources. The sources subject to these provisions emit the HAPs epichlorohydrin, and in lesser amounts, hydrochloric acid and methanol. Respondents are owners or operators of new and existing facilities that manufacture polymers and resins from epichlorohydrin. Source categories include basic liquid epoxy resin (BLR) producers and producers of epichlorohydrin-modified non-nylon polyamide resins, also known as wet strength resins (WSR). Any owner or operator subject to the provisions of this part shall maintain a file of these measurements, and retain the file for at least five years following the date of such measurements, maintenance reports, and records. All reports are sent to the delegated State or local authority. In the event that there is no such delegated authority, the reports are sent directly to the EPA regional office. This information is being collected to assure compliance with 40 CFR part 63, subpart W, and 40 CFR part 63, Subpart A, as authorized in section 112 and 114(a) of the Clean Air Act. The required information consists of emissions data and other information that have been determined to be private. An agency may not conduct or sponsor, and a person is not required to respond to, a collection of information unless it displays a currently valid OMB Control Number. The OMB Control Number for EPA's regulations are listed in 40 CFR part 9 and 48 CFR chapter 15, and are identified on the form and/or instrument, if applicable. Burden Statement: The annual public reporting and recordkeeping burden for this collection of information is estimated to average 214 hours per response. Burden means the total time, effort, or financial resources expended by persons to generate, maintain, retain, or disclose or provide information to or for a Federal agency. This includes the time needed to review instructions; develop, acquire, install, and utilize technology and systems for the purpose of collecting, validating, and verifying information, processing and maintaining, information, and disclosing and providing information. All existing ways will have to adjust to comply with any previously applicable instructions and requirements that have subsequently changed; train personnel to be able to respond to a collection of information; search data sources; complete and review the collection of information; and transmit or otherwise disclose the information. Respondents/Affected Entities: Epoxy resin and non-nylon polyamide production. Estimated Number of Respondents: 7. Frequency of Response: Semiannually, quarterly and initially. Estimated Total Annual Hour Burden: 3,853. Estimated Total Annual Cost: $370,463, which includes $361,463 in labor costs, no capital/startup costs, and $9,000 in operation and maintenance (O&M) costs. Changes in the Estimates: There is no increase in the number of affected facilities, labor hours, or the number of responses compared to the previous ICR. There is, however, an increase in the estimated labor burden cost as currently identified in the OMB Inventory of Approved Burdens. This increase is not due to any program change. The change in the labor burden cost estimates has occurred because we updated the labor rates, which resulted in an increase in cost. Dated: April 4, 2011. John Moses, Director, Collection Strategies Division. [FR Doc. 2011-8426 Filed 4-7-11; 8:45 am] BILLING CODE 6560-50-P