[Federal Register Volume 76, Number 71 (Wednesday, April 13, 2011)]
[Rules and Regulations]
[Pages 20550-20551]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 2011-8794]


-----------------------------------------------------------------------

ENVIRONMENTAL PROTECTION AGENCY

40 CFR Part 1042


Control of Emissions From New and In-Use Marine Compression-
Ignition Engines and Vessels

CFR Correction

    In Title 40 of the Code of Federal Regulations, Part 1000 to End, 
revised as of July 1, 2010, on page 240, in Sec.  1042.901, the 
definition of ``New vessel'' is reinstated to read as follows:


Sec.  1042.901  Definitions.

* * * * *
    New vessel means any of the following:
    (1) A vessel for which the ultimate purchaser has never received 
the equitable or legal title. The vessel is no longer new when the 
ultimate purchaser receives this title or it is placed into service, 
whichever comes first.
    (2) For vessels with no Category 3 engines, a vessel that has been 
modified such that the value of the modifications exceeds 50 percent of 
the value of the modified vessel, excluding temporary modifications (as 
defined in this section). The value of the modification is the 
difference in the assessed value of the vessel before the modification 
and the assessed value of the vessel after the

[[Page 20551]]

modification. The vessel is no longer new when it is placed into 
service. Use the following equation to determine if the fractional 
value of the modification exceeds 50 percent:
    Percent of value = [(Value after modification)(Value before 
modification)] x 100% / (Value after modification)
    (3) For vessels with Category 3 engines, a vessel that has 
undergone a modification that substantially alters the dimensions or 
carrying capacity of the vessel, changes the type of vessel, or 
substantially prolongs the vessel's life.
    (4) An imported vessel that has already been placed into service, 
where it has an engine not covered by a certificate of conformity 
issued under this part at the time of importation that was manufactured 
after the requirements of this part start to apply (see Sec.  1042.1).
* * * * *
[FR Doc. 2011-8794 Filed 4-12-11; 8:45 am]
BILLING CODE 1505-01-D