[Federal Register Volume 76, Number 91 (Wednesday, May 11, 2011)]
[Notices]
[Pages 27367-27369]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 2011-11457]
-----------------------------------------------------------------------
DEPARTMENT OF LABOR
Occupational Safety and Health Administration
[Docket No. OSHA-2011-0063]
Slings; Extension of the Office of Management and Budget's (OMB)
Approval of Information Collection (Paperwork) Requirements
AGENCY: Occupational Safety and Health Administration (OSHA), Labor.
ACTION: Request for public comments.
-----------------------------------------------------------------------
SUMMARY: OSHA solicits public comments concerning its proposal to
extend OMB approval of the information collection requirements
contained in the Standard on Slings (29 CFR 1910.184). The collection
of information (paperwork) provisions of the Standard specify affixing
identification tags or markings on slings, developing and maintaining
inspection records, and retaining proof testing certificates.
DATES: Comments must be submitted (postmarked, sent, or received) by
July 11, 2011.
ADDRESSES: Electronically: You may submit comments and attachments
electronically at http://www.regulations.gov, which is the Federal
eRulemaking Portal. Follow the instructions online for submitting
comments.
Facsimile: If your comments, including attachments, are not longer
than 10 pages, you may fax them to the OSHA Docket Office at (202) 693-
1648.
Mail, hand delivery, express mail, messenger, or courier service:
When using this method, you must submit a copy of your comments and
attachments to the OSHA Docket Office, Docket No. OSHA-2011-0063, U.S.
Department of Labor, Occupational Safety and Health Administration,
Room N-2625, 200 Constitution Avenue, NW., Washington, DC 20210.
Deliveries (hand, express mail, messenger, and courier service) are
accepted during the Department of Labor's and Docket Office's normal
business hours, 8:15 a.m. to 4:45 p.m., e.t.
Instructions: All submissions must include the Agency name and OSHA
docket number (OSHA-2011-0063) for the Information Collection Request
(ICR). All comments, including any personal information you provide,
are placed in the public docket without change, and may be made
available online at http://www.regulations.gov. For further information
on submitting comments see the ``Public Participation'' heading in the
section of this notice titled SUPPLEMENTARY INFORMATION.
Docket: To read or download comments or other material in the
docket, go to http://www.regulations.gov or the OSHA Docket Office at
the address above. All documents in the docket (including this Federal
Register notice) are listed in the http://www.regulations.gov index;
however, some information (e.g., copyrighted material) is not publicly
available to read or download through the Web site. All submissions,
including copyrighted material, are available for inspection and
copying at the OSHA Docket Office. You may also contact Theda Kenney at
the address below to obtain a copy of the ICR.
FOR FURTHER INFORMATION CONTACT: Theda Kenney or Todd Owen, Directorate
of Standards and Guidance, OSHA, U.S. Department of Labor, Room N-3609,
200 Constitution Avenue, NW., Washington, DC 20210; telephone (202)
693-2222.
SUPPLEMENTARY INFORMATION:
I. Background
The Department of Labor, as part of its continuing effort to reduce
paperwork and respondent (i.e., employer) burden, conducts a
preclearance consultation program to provide the public with an
opportunity to comment on proposed and continuing information
collection requirements in accordance with the Paperwork Reduction Act
of 1995 (44 U.S.C. 3506(c)(2)(A)). This program ensures that
information is in the desired format, reporting burden (time and costs)
is minimal, collection instruments are clearly understood, and OSHA's
estimate of the information collection burden is accurate. The
Occupational Safety and Health Act of 1970 (the OSH Act) (29 U.S.C. 651
et seq.) authorizes information collection by employers as necessary or
appropriate for enforcement of the OSH Act or for developing
information regarding the causes and prevention of occupational
injuries, illnesses, and accidents (29 U.S.C. 657). The OSH Act also
requires that OSHA obtain such information with minimum burden upon
employers, especially those operating small businesses, and to reduce
to the maximum extent feasible unnecessary duplication of efforts in
obtaining information (29 U.S.C. 657).
The Slings Standard (29 CFR 1910.184) specifies several collection
of information (paperwork) requirements, depending on the type of
sling. The purpose of each of these requirements is to prevent workers
from using defective or deteriorated slings, thereby reducing their
risk of death or serious injury
[[Page 27368]]
caused by sling failure during material handling.
Paragraph (e) of the Standard covers alloy steel chain slings.
Paragraph (e)(1) requires that alloy steel chain slings have
permanently affixed and durable identification stating the size, grade,
rated capacity, and reach of the sling. The information, supplied by
the manufacturer, is typically marked on a metal tag and affixed to the
sling.
Paragraph (e)(3)(i) requires the employer to make a thorough
periodic inspection of alloy steel chain slings in use on a regular
basis, but at least once a year. Paragraph (e)(3)(ii) requires the
employer to make and maintain a record of the most recent month in
which each alloy steel chain sling was thoroughly inspected, and make
this record available for examination.
Paragraph (e)(4) requires the employer to retain certificates of
proof testing. Employers must ensure that before use, each new,
repaired, or reconditioned alloy steel chain sling, including all
welded components in the sling assembly, has been proof tested by the
sling manufacturer or an equivalent entity. The certificates of proof
testing must be retained by the employer and made available for
examination.
Paragraph (f) of the Standard covers wire rope slings. Paragraph
(f)(4)(ii) requires that all welded end attachments of wire rope slings
be proof tested by the manufacturer at twice their rated capacity prior
to initial use, and that the employer retain a certificate of the proof
test and make it available for examination.
Paragraph (g) of the Standard covers metal mesh slings. Paragraph
(g)(1) requires each metal mesh sling to have a durable marking
permanently affixed that states the rated capacity for vertical basket
hitch and choker hitch loadings. Paragraph (g)(8)(ii) requires that
once repaired, each metal mesh sling be permanently marked or tagged,
or a written record maintained to indicate the date and type of the
repairs made, and the person or organization that performed the
repairs. Records of the repairs shall be made available for
examination.
Paragraph (i) of the Standard covers synthetic web slings.
Paragraph (i)(1) requires that synthetic web slings be marked or coded
to show the rated capacities for each type of hitch and the type of
synthetic web material used in the sling.
Paragraph (i)(8)(i) prohibits the use of repaired synthetic web
slings until they have been proof tested by the manufacturer or an
equivalent entity. Paragraph (i)(8)(ii) requires the employer to retain
a certificate of the proof test and make it available for examination.
The information on the identification tags, markings, and codings
assist the employer in determining whether the sling can be used for
the lifting task. The sling inspections enable early detection of
faulty slings. The inspection and repair records provide employers with
information about when the last inspection was made and about the type
of the repairs made. This information provides some assurance about the
condition of the slings. These records also provide the most efficient
means for an OSHA compliance officer to determine that an employer is
complying with the Standard. Proof testing certificates give employers,
employees, and OSHA compliance officers assurance that slings are safe
to use. The certificates also provide the compliance officers with an
efficient means to assess employer compliance with the Standard.
II. Special Issues for Comment
OSHA has a particular interest in comments on the following issues:
Whether the proposed information collection requirements
are necessary for the proper performance of the Agency's functions,
including whether the information is useful;
The accuracy of OSHA's estimate of the burden (time and
costs) of the information collection requirements, including the
validity of the methodology and assumptions used;
The quality, utility, and clarity of the information
collected; and
Ways to minimize the burden on employers who must comply;
for example, by using automated or other technological information
collection and transmission techniques.
III. Proposed Actions
OSHA is requesting that OMB extend its approval of the information
collection requirements contained in the Standard on Slings (29 CFR
1910.184). OSHA is proposing to increase the existing burden hour
estimate for the collection of information requirements specified by
the Standard from 17,760 to 19,833 hours, a total increase of 2,073
hours. The increase occurred as a result of an overall increase in the
total number of slings. The Agency will summarize the comments
submitted in response to this notice and will include this summary in
the request to OMB.
Type of Review: Extension of a currently approved collection.
Title: Slings (29 CFR 1910.184).
OMB Number: 1218-0223.
Affected Public: Business or other for-profits; Not-for-profit
organizations; Federal Government; State, Local, or Tribal Government.
Number of Respondents: 1,116,667.
Frequency of Response: On occasion.
Average Time per Response: Varies from 1 minute (.02 hour) to
maintain a certificate to 30 minutes (.50 hour) for a manufacturing
employee to acquire information from a manufacturer for a new tag, make
a new tag, and affix it to a sling.
Estimated Total Burden Hours: 19,833.
Estimated Cost (Operation and Maintenance): $0.
IV. Public Participation--Submission of Comments on This Notice and
Internet Access to Comments and Submissions
You may submit comments in response to this document as follows:
(1) Electronically at http://www.regulations.gov, which is the Federal
eRulemaking Portal; (2) by facsimile (fax); or (3) by hard copy. All
comments, attachments, and other material must identify the Agency name
and the OSHA docket number for the ICR (Docket No. OSHA-2011-0063). You
may supplement electronic submissions by uploading document files
electronically. If you wish to mail additional materials in reference
to an electronic or facsimile submission, you must submit them to the
OSHA Docket Office (see the section of this notice titled ADDRESSES).
The additional materials must clearly identify your electronic comments
by your name, date, and the docket number so the Agency can attach them
to your comments.
Because of security procedures, the use of regular mail may cause a
significant delay in the receipt of comments. For information about
security procedures concerning the delivery of materials by hand,
express delivery, messenger, or courier service, please contact the
OSHA Docket Office at (202) 693-2350, (TTY (877) 889-5627).
Comments and submissions are posted without change at http://www.regulations.gov. Therefore, OSHA cautions commenters about
submitting personal information such as social security numbers and
date of birth. Although all submissions are listed in the http://www.regulations.gov index, some information (e.g., copyrighted
material) is not publicly available to read or download through this
Web site. All submissions, including copyrighted material, are
available for inspection and copying at the OSHA Docket Office.
Information on using the http://www.regulations.gov Web site to submit
comments and access the docket is
[[Page 27369]]
available at the Web site's ``User Tips'' link. Contact the OSHA Docket
Office for information about materials not available through the Web
site, and for assistance in using the Internet to locate docket
submissions.
V. Authority and Signature
David Michaels, PhD, MPH, Assistant Secretary of Labor for
Occupational Safety and Health, directed the preparation of this
notice. The authority for this notice is the Paperwork Reduction Act of
1995 (44 U.S.C. 3506 et seq.) and Secretary of Labor's Order No. 5-2010
(72 FR 55355).
Signed at Washington, DC on May 5, 2011.
David Michaels,
Assistant Secretary of Labor for Occupational Safety and Health.
[FR Doc. 2011-11457 Filed 5-10-11; 8:45 am]
BILLING CODE 4510-26-P