[Federal Register Volume 76, Number 220 (Tuesday, November 15, 2011)]
[Notices]
[Pages 70803-70804]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 2011-29286]


=======================================================================
-----------------------------------------------------------------------

SELECTIVE SERVICE SYSTEM


Form Submitted to the Office of Management and Budget for 
Extension of Clearance

AGENCY: Selective Service System.

ACTION: Notice.

-----------------------------------------------------------------------

    The following forms have been submitted to the Office of Management 
and Budget (OMB) for extension of clearance in compliance with the 
Paperwork Reduction Act (44 U.S.C. Chapter 35):

SSS Form--2, 3A, 3B and 3C

    Title: Selective Service System Change of Information, Correction/
Change Form and Registration Status Forms.
    Purpose: To insure the accuracy and completeness of the Selective 
Service System registration data.
    Respondents: Registrants are required to report changes or 
corrections submitted on SSS Form 1.
    Burden: A burden of two minutes or less on the individual 
respondent.
    Copies of the above identified forms can be obtained upon written 
request to the Selective Service System, Reports Clearance Officer, 
1515 Wilson Boulevard, Arlington, Virginia 22209-2425.
    Written comments and recommendations for the proposed extension of 
clearance of the form

[[Page 70804]]

should be sent within 30 days of the publication of this notice to the 
Selective Service System, Reports Clearance Officer, 1515 Wilson 
Boulevard, Arlington, Virginia 22209-2425.
    A copy of the comments should be sent to the Office of Information 
and Regulatory Affairs, Attention: Desk Officer, Selective Service 
System, Office of Management and Budget, New Executive Office Building, 
Room 3235, Washington, DC 20503.

    Dated: October 4, 2011.
Lawrence G. Romo,
Director.
[FR Doc. 2011-29286 Filed 11-14-11; 8:45 am]
BILLING CODE 8015-01-M