[Federal Register Volume 78, Number 54 (Wednesday, March 20, 2013)] [Rules and Regulations] [Pages 17075-17076] From the Federal Register Online via the Government Publishing Office [www.gpo.gov] [FR Doc No: 2013-06170] ----------------------------------------------------------------------- DEPARTMENT OF TRANSPORTATION Federal Aviation Administration 14 CFR Part 39 [Docket No. FAA-2012-1031; Directorate Identifier 2012-NE-31-AD; Amendment 39-17391; AD 2013-05-19] RIN 2120-AA64 Airworthiness Directives; Rolls-Royce Deutschland Ltd & Co KG Turbofan Engines AGENCY: Federal Aviation Administration (FAA), DOT. ACTION: Final rule. ----------------------------------------------------------------------- SUMMARY: We are adopting a new airworthiness directive (AD) for certain Rolls-Royce Deutschland Ltd & Co KG (RRD) Tay 611-8 turbofan engines. This AD requires inspection and replacement, if necessary, of affected bolts. This AD was prompted by a quality review determination that bolts with reduced material properties may have been installed in some engines. We are issuing this AD to prevent uncontained turbine disc fracture and damage to the airplane. DATES: This AD becomes effective April 24, 2013. ADDRESSES: The Docket Operations office is located at Docket Management Facility, U.S. Department of Transportation, 1200 New Jersey Avenue SE., West Building Ground Floor, Room W12-140, Washington, DC 20590- 0001. FOR FURTHER INFORMATION CONTACT: Frederick Zink, Aerospace Engineer, Engine Certification Office, FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803; email: [email protected]; telephone: 781-238-7779; fax: 781-238-7199. SUPPLEMENTARY INFORMATION: Discussion We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to include an AD that would apply to the specified products. That NPRM was published in the Federal Register on November 13, 2012 (77 FR 67582). That NPRM proposed to correct an unsafe condition for the specified products. The Mandatory Continuing Airworthiness Information states: The results of a recent quality review of low pressure turbine (LPT) stage 1 static air seal and high pressure turbine (HPT) stage 1 air seal support bolts identified that, before installation, those bolts may have not been inspected. As a consequence, bolts with reduced material properties may have been installed in some engines. This condition, if not detected and corrected, could lead to failure of a bolt, potentially causing turbine disc fracture and release of high-energy debris, possibly resulting in damage to the aeroplane and/or injury to the occupants. Comments We gave the public the opportunity to participate in developing this AD. We received no comments on the NPRM (77 FR 67582, November 13, 2012). However, we changed paragraph (e) of this AD by removing the reporting requirement because that requirement is not necessary to correct the unsafe condition. Conclusion We reviewed the available data and determined that air safety and the public interest require adopting the AD as proposed (77 FR 67582, November 13, 2012). Costs of Compliance Based on the service information, we estimate that this AD affects about 20 engines of U.S. registry. We also estimate that it will take about 4 hours per product to comply with this AD. The average labor rate is $85 per hour. Required parts will cost about $1,848 per engine. Based on these figures, we estimate the cost of the AD on U.S. operators to be $43,760. Authority for This Rulemaking Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority. We are issuing this rulemaking under the authority described in ``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on [[Page 17076]] products identified in this rulemaking action. Regulatory Findings We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. For the reasons discussed above, I certify this AD: 1. Is not a ``significant regulatory action'' under Executive Order 12866; 2. Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); 3. Will not affect intrastate aviation in Alaska to the extent that it justifies making a regulatory distinction, and 4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. We prepared a regulatory evaluation of the estimated costs to comply with this AD and placed it in the AD docket. Examining the AD Docket You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (phone: (800) 647-5527) is provided in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt. List of Subjects in 14 CFR Part 39 Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety. Adoption of the Amendment Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: PART 39--AIRWORTHINESS DIRECTIVES 0 1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. Sec. 39.13 [Amended] 0 2. The FAA amends Sec. 39.13 by adding the following new AD: 2013-05-19 Rolls-Royce Deutschland Ltd & Co KG: Amendment 39-17391; Docket No. FAA-2012-1031; Directorate Identifier 2012-NE-31-AD. (a) Effective Date This airworthiness directive (AD) becomes effective April 24, 2013. (b) Affected ADs None. (c) Applicability This AD applies to Rolls-Royce Deutschland Ltd & Co KG (RRD) Tay 611-8 turbofan engines, serial numbers 16245, 16256, 16417, 16418, 16584, 16585, 16639, 16640, 16701, 16702, 16813, 16814, 16853, 16854, 16879, 16880, 16898, 16905, 16906, 16911, 16923, 16935, and 16936, with a date of the last shop visit before December 8, 2006. (d) Reason This AD was prompted by a recent quality review determination that bolts with reduced material properties may have been installed in some engines. We are issuing this AD to prevent uncontained turbine disc fracture and damage to the airplane. (e) Actions and Compliance Unless already done, for engines with a date of the last shop visit before December 8, 2006, do the following actions: (1) If engine cycles accumulated since the last engine shop visit is 5,400 cycles or more on the effective date of this AD, inspect the bolts installed in the low-pressure turbine (LPT) stage 1 static seal and high-pressure turbine (HPT) stage 1 air seal support within 100 engine cycles-in-service after the effective date of this AD. (2) If engine cycles accumulated since the last engine shop visit is fewer than 5,400 cycles on the effective date of this AD, inspect the bolts installed in the LPT stage 1 static seal and HPT stage 1 air seal support before accumulating 5,500 engine cycles since the last engine shop visit. (3) If you find any broken bolt, brown bolt, or bolt with a rough oxidized surface, then replace all bolts of the inspected engine flange with new bolts before further flight. (f) Installation Prohibition After the effective date of this AD, do not install any HPT module and/or LPT module into any engine, or any engine onto an airplane, unless the bolts have been inspected and replaced if necessary, as specified in paragraph (e) of this AD. (g) Alternative Methods of Compliance (AMOCs) The Manager, Engine Certification Office, FAA, may approve AMOCs to this AD. Use the procedures found in 14 CFR 39.19 to make your request. (h) Related Information (1) For more information about this AD, contact Frederick Zink, Aerospace Engineer, Engine Certification Office, FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803; phone: 781-238-7779; fax: 781-238-7199; email: [email protected]. (2) Refer to European Aviation Safety Agency AD 2012-0163, dated August 28, 2012, and RRD Alert Service Bulletin TAY-72-A1696, Revision 1, dated June 11, 2012, for related information. (3) For service information identified in this AD, contact Rolls-Royce Deutschland Ltd & Co KG, Eschenweg 11, Dahlewitz, 15827 Blankenfelde-Mahlow, Germany; phone: 49 0 33-7086-1200 (direct 1016); fax: 49 0 33-7086-1212. You may view this service information at the FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA. For information on the availability of this material at the FAA, call 781-238-7125. (i) Material Incorporated by Reference None. Issued in Burlington, Massachusetts, on March 7, 2013. Colleen M. D'Alessandro, Assistant Manager, Engine & Propeller Directorate, Aircraft Certification Service. [FR Doc. 2013-06170 Filed 3-19-13; 8:45 am] BILLING CODE 4910-13-P