[Federal Register Volume 78, Number 99 (Wednesday, May 22, 2013)] [Notices] [Pages 30391-30392] From the Federal Register Online via the Government Publishing Office [www.gpo.gov] [FR Doc No: 2013-12007] [[Page 30391]] ----------------------------------------------------------------------- DEPARTMENT OF TRANSPORTATION Pipeline and Hazardous Materials Safety Administration Notice of Applications for Modification of Special Permits AGENCY: Pipeline and Hazardous Materials Safety Administration (PHMSA), DOT. ACTION: List of Applications for Modification of Special Permits. ----------------------------------------------------------------------- SUMMARY: In accordance with the procedures governing the application for, and the processing of, special permits from the Department of Transportation's Hazardous Material Regulations (49 CFR part 107, subpart B), notice is hereby given that the Office of Hazardous Materials Safety has received the applications described herein. This notice is abbreviated to expedite docketing and public notice. Because the sections affected, modes of transportation, and the nature of application have been shown in earlier Federal Register publications, they are not repeated here. Requests for modification of special permits (e.g. to provide for additional hazardous materials, packaging design changes, additional mode of transportation, etc.) are described in footnotes to the application number. Application numbers with the suffix ``M'' denote a modification request. These applications have been separated from the new application for special permits to facilitate processing. DATES: Comments must be received on or before June 6, 2013. Address Comments To: Record Center, Pipeline and Hazardous Materials Safety Administration, U.S. Department of Transportation, Washington, DC 20590. Comments should refer to the application number and be submitted in triplicate. If confirmation of receipt of comments is desired, include a self-addressed stamped postcard showing the special permit number. FOR FURTHER INFORMATION CONTACT: Copies of the applications are available for inspection in the Records Center, East Building, PHH-30, 1200 New Jersey Avenue Southeast, Washington DC or at http://regulations.gov. This notice of receipt of applications for modification of special permit is published in accordance with Part 107 of the Federal hazardous materials transportation law (49 U.S.C. 5117(b); 49 CFR 1.53(b)). Issued in Washington, DC, on May 10, 2013. Donald Burger, Chief, General Approvals and Permits. Modification Special Permits ---------------------------------------------------------------------------------------------------------------- Regulation(s) Nature of special permit Application No. Docket No. Applicant affected thereof ---------------------------------------------------------------------------------------------------------------- 6263-M................ .............. Amtrol, Inc., West 49 CFR 173.302(a)(1). To modify the special Warwick, RI. permit to authorize a decrease in hydrostatic testing to 1.3 times MAWP and pneumatic testing to 1.1 times MAWP. 8228-M................ .............. U.S. Department of 49 CFR 172.101(c), To modify the special Justice, Bureau of 172.203(k), 172.102, permit to authorize an Alcohol, Tobacco, and 173.56(b). alternative packaging. Firearms and Explosives (ATF), Washington, DC. 8843-M................ .............. Diamondback 49 CFR 173.228, To modify the special Industries, Inc., 174.3, 175.3, 176.3, permit to authorize an Crowley, TX. and 177.801. inside diameter of 1-\1/ 2\ inches maximum for 4131 seamless steel tubing cylinder. 10704-M............... .............. Air Liquide America 49 CFR 173.302(a)(1), To modify the special Speciality Gases Part 172 Subpart C, permit to authorize a LLC, Plumsteadville, E and F, Part 174, lower minimum burst PA. and Part 177. pressure and pressure rating. 11592-M............... .............. Amtrol Inc., West 49 CFR 173.306(g).... To modify the special Warwick, RI. permit to allow tanks 11 inches and under in diameter to be allowed to have a precharge of 70 psig and a wall stress of 38,000 psig. 11667-M............... .............. Weldship Corporation, 49 CFR 173.34(e), and To modify the special Bethlehem, PA. 173.302(c)(2), (3), permit and to authorize (4). neck thread requirements that are consistant with CGA Pamphlet C-23. 12122-M............... .............. ARC Automotive, Inc., 49 CFR 173.301(h), To modify the and special Knoxville, TN. 173.302, permit to authorize new 173.306(d)(3). opening and attachment requirements. 12184-M............... .............. Weldship Corporation, 49 CFR 173.34(e)(1), To modify the special Bethlehem, PA. 173.302(c)(2)(3)(4), permit to authorize neck 173.34(e)(3), thread requirements that 173.34(e)(4), and are consistant with CGA 173.34(e)(6). Pamphlet C-23. 13424-M............... .............. Taminco, Inc., 49 CFR 177.834(i)(3), To modify the special Allentown, PA. 172.203(a), and permit to remove the 172.302(c). requirement that the video camera must be capable of panning. 14770-M............... .............. Nova Chemicals 49 CFR 173.242....... To modify the special Corporation, Moon permit to authorize a Township, PA. Division 4.2 material. 14784-M............... .............. Weldship Corporation, 49 CFR 180.209(a) and To modify the special Bethlehem, PA. (b). permit to authorize neck thread requirements that are consistant with CGA Pamphlet C-23. 14839-M............... .............. Matheson Tri-Gas, 49 CFR 180.209....... To modify the special Inc., New Castle, PA. permit to authorize new flat bottom hole dimensions when conducting ultrasonic examination for the purpose of cylinder requalification. [[Page 30392]] 14856-M............... .............. BKC Industries, Inc., 49 CFR 180.209(a) and To modify the special Creedmoor, NC. (b). permit to authorize neck thread requirements that are consistant with CGA Pamphlet C-23. 14920-M............... .............. Nordco Rail Services 49 CFR 173.302a, To modify the special & Inspection 180.205, and 180.209. permit to authorize 3A, Technologies, 3AL, and DOT-SP 12440 Ridgefield, CT. cylinders to be retested by a 100% ultrasonic examination, marking requirements equal to or less than 5 inches, different dimensions of a flat bottom hole to be used during ultrasonic examinations, and add an acceptable level of tolerance to the maximum achieved reference amplitude. 15558-M............... .............. 3M Company, St. Paul, 49 CFR 173.212, To modify the special MN. 172.302(a)(c). permit to authorize alternative packaging with a maximum capacity of 400 gallons. ---------------------------------------------------------------------------------------------------------------- [FR Doc. 2013-12007 Filed 5-21-13; 8:45 am] BILLING CODE 4909-60-M