[Federal Register Volume 79, Number 190 (Wednesday, October 1, 2014)]
[Proposed Rules]
[Pages 59153-59154]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 2014-23417]
========================================================================
Proposed Rules
Federal Register
________________________________________________________________________
This section of the FEDERAL REGISTER contains notices to the public of
the proposed issuance of rules and regulations. The purpose of these
notices is to give interested persons an opportunity to participate in
the rule making prior to the adoption of the final rules.
========================================================================
Federal Register / Vol. 79, No. 190 / Wednesday, October 1, 2014 /
Proposed Rules
[[Page 59153]]
DEPARTMENT OF ENERGY
10 CFR Part 431
[Docket Number EERE-2014-BT-PET-0041]
Energy Conservation Program for Certain Commercial and Industrial
Equipment: Walk-in Coolers and Freezers; Test Procedure
AGENCY: Office of Energy Efficiency and Renewable Energy, Department of
Energy.
ACTION: Notice of public meeting.
-----------------------------------------------------------------------
SUMMARY: The Department of Energy (DOE) is planning to hold a public
meeting to discuss the various aspects related to testing and
calculating the energy efficiency ratings for refrigeration systems
used in walk-in coolers and freezers (WICFs). The discussion will focus
solely on the mechanics of measuring the relevant values and the
downstream calculations needed to rate the efficiency of WICF
refrigeration system basic models that are either sold as mixed or
matched systems.
DATES: Meeting: DOE will hold a public meeting on Wednesday, October
22, 2014 from 9:00 a.m. to 1:00 p.m. in Washington, DC. In addition,
DOE plans to broadcast the public meeting via webinar. You may attend
the public meeting either in person or via webinar. Registration
information, participant instructions, and also information about the
capabilities available to webinar participants will be published in
advance on DOE's Web site at: http://www.eere.energy.gov/buildings/appliance_standards/product.aspx/productid/26. Webinar
participants are responsible for ensuring their systems are compatible
with the webinar software.
ADDRESSES: U.S. Department of Energy, Forrestal Building, 1000
Independence Avenue SW., Washington, DC 20585, Room GH-019. To attend,
please notify Ms. Brenda Edwards at (202) 586-2945. Please note that
foreign nationals visiting DOE Headquarters are subject to advance
security screening procedures. Any foreign national wishing to
participate in the meeting should advise DOE as soon as possible by
contacting Ms. Edwards to initiate the necessary procedures. Please
also note that any person wishing to bring a laptop into the Forrestal
Building will be required to obtain a property pass. Visitors should
avoid bringing laptops, or allow an extra 45 minutes. Persons may also
attend the public meeting via webinar.
Due to the REAL ID Act implemented by the Department of Homeland
Security (DHS), there have been recent changes regarding ID
requirements for individuals wishing to enter Federal buildings from
specific states and U.S. territories. Driver's licenses from the
following states or territory will not be accepted for building entry
and one of the alternate forms of ID listed below will be required.
DHS has determined that regular driver's licenses (and ID cards)
from the following jurisdictions are not acceptable for entry into DOE
facilities: Alaska, American Samoa, Arizona, Louisiana, Maine,
Massachusetts, Minnesota, New York, Oklahoma, and Washington.
Acceptable alternate forms of Photo-ID include: U.S. Passport or
Passport Card; an Enhanced Driver's License or Enhanced ID-Card issued
by the states of Minnesota, New York or Washington (Enhanced licenses
issued by these states are clearly marked Enhanced or Enhanced Driver's
License); a military ID or other Federal government issued Photo-ID
card.
FOR FURTHER INFORMATION CONTACT: Ashley Armstrong, U.S. Department of
Energy, Office of Energy Efficiency and Renewable Energy, Building
Technologies Program, EE-5B, 1000 Independence Avenue SW., Washington,
DC 20585-0121, (202) 586-6590, email: [email protected].
Michael Kido, U.S. Department of Energy, Office of General Counsel, GC-
71, 1000 Independence Avenue SW., Washington, DC 20585, (202) 586-8145,
email: [email protected].
SUPPLEMENTARY INFORMATION: The U.S. Department of Energy (DOE) is
holding a public meeting to discuss a variety of issues related to the
testing and calculation of the energy efficiency of refrigeration
systems used in walk-in coolers and walk-in freezers (collectively,
``walk-ins'' or ``WICFs''). A walk-in is an enclosed storage space
refrigerated to temperatures ``above, and at or below'' (depending on
whether it is a cooler or freezer) 32 [deg]F that can be walked into,
and has a total chilled storage area of less than 3,000 square feet.
See 42 U.S.C. 6311(20). Each walk-in is comprised of three key types of
components: Panels used for the ceiling, walls, and (for freezers) the
floor; at least one door; and a refrigeration system.
At its most basic level, a refrigeration system uses two primary
components--an evaporator coil unit and a condensing unit. Both of
these components are connected together through the use of a
refrigerant line. Within the refrigeration system market, some
manufacturers produce both components, effectively creating a complete
system for purposes of being able to rate the efficiency of a given
walk-in refrigeration system. Other manufacturers, however, produce
only the evaporator coils or the condensing unit. Recent modifications
to DOE's WICF test procedure enable manufacturers in these single
component-only scenarios to readily calculate the energy efficiency of
their respective unit using specified default values for the other
refrigeration system component that they do not manufacture. See 79 FR
27388 (May 13, 2014). Those recent modifications also allow
manufacturers of walk-in refrigeration systems to use a mathematical
model or computer simulation, known generically as alternative
efficiency determination methods (AEDMs), in lieu of conducting a test
when rating a WICF refrigeration system's energy efficiency.
The scheduled meeting is intended to assist interested parties,
particularly those individual manufacturers who produce only one of the
two primary refrigeration system components noted above, with applying
DOE's calculation methodology when rating the efficiency of that
manufacturer's component. This calculation methodology must be used
when determining whether a manufacturer's individual component complies
with the applicable energy conservation standards DOE recently issued,
compliance with which is required as of June 5, 2017. See 79 FR 32050
(June 3, 2014).
DOE plans to discuss the following issues:
[[Page 59154]]
The scope of the refrigeration system test procedure,
particularly, identifying which refrigeration components fall within
the scope of DOE's walk-in regulations;
the operation of the test procedure's methodology,
including the methods used to calculate defrost energy consumption;
the application of the test procedure when rating
different walk-in refrigeration systems (i.e., mixed versus matched
systems);
the calculation of the ratings of a given walk-in
refrigeration system component when only component (i.e. the evaporator
coil unit or condenser unit) is produced; and
the AEDM requirements as they apply to walk-in
refrigeration systems.
DOE encourages all interested persons to submit questions to DOE
that are relevant to the above topics in advance of the meeting date to
ensure that the agency is able to fully address these topics. As the
intent of this meeting is to help manufacturers to better understand
how to rate their equipment, DOE will not be discussing the methodology
or analysis used in developing the recently amended energy conservation
standards for walk-in refrigeration systems.
Issued in Washington, DC, on September 23, 2014.
Kathleen B. Hogan,
Deputy Assistant Secretary for Energy Efficiency, Energy Efficiency and
Renewable Energy.
[FR Doc. 2014-23417 Filed 9-30-14; 8:45 am]
BILLING CODE 6450-01-P