[Federal Register Volume 80, Number 209 (Thursday, October 29, 2015)]
[Notices]
[Page 66489]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 2015-27620]
-----------------------------------------------------------------------
DEPARTMENT OF COMMERCE
Foreign-Trade Zones Board
[B-68-2015]
Foreign-Trade Zone (FTZ) 102--St. Louis, Missouri; Notification
of Proposed Production Activity; H-J Enterprises, Inc./H-J
International, Inc. (Electrical Transformer Bushing Assemblies); High
Ridge, Missouri
The St. Louis County Port Authority, grantee of FTZ 102, submitted
a notification of proposed production activity to the FTZ Board on
behalf of H-J Enterprises, Inc./H-J International, Inc. (H-J), located
at two sites in High Ridge, Missouri. The notification conforming to
the requirements of the regulations of the FTZ Board (15 CFR 400.22)
was received on October 20, 2015.
A separate application for subzone designation at the H-J
facilities is planned and will be processed under Section 400.31 of the
FTZ Board's regulations. The facilities are used for the production of
electrical transformer bushing assemblies for utility companies.
Pursuant to 15 CFR 400.14(b), FTZ activity would be limited to the
specific foreign-status materials and components and specific finished
products described in the submitted notification (as described below)
and subsequently authorized by the FTZ Board.
Production under FTZ procedures could exempt H-J from customs duty
payments on the foreign-status components used in export production. On
its domestic sales, H-J would be able to choose the duty rates during
customs entry procedures that apply to porcelain and epoxy electrical
transformer bushing assemblies (duty rates 2.7% and 3%, respectively)
for the foreign-status inputs noted below. Customs duties also could
possibly be deferred or reduced on foreign-status production equipment.
The components and materials sourced from abroad include: Rubber
bushing plugs; iron/steel bolts, screws, studs and washers; steel
ground pads; copper tubes, studs and terminals; brass washers, bolts,
screws, nuts, studs and terminals; aluminum/steel bushing inserts and
caps; aluminum clamps and plugs; steel hinges, steel/brass fittings and
connectors; copper/brass/steel drain valves; steel/brass inserts and
bushing caps; bayonet fuses; porcelain/epoxy bushing assemblies; fuse
end bells; electrical leads; porcelain insulators; and level gauges
(duty rates range from 1.8% to 8.5%).
Public comment is invited from interested parties. Submissions
shall be addressed to the FTZ Board's Executive Secretary at the
address below. The closing period for their receipt is December 8,
2015.
A copy of the notification will be available for public inspection
at the Office of the Executive Secretary, Foreign-Trade Zones Board,
Room 21013, U.S. Department of Commerce, 1401 Constitution Avenue NW.,
Washington, DC 20230-0002, and in the ``Reading Room'' section of the
FTZ Board's Web site, which is accessible via www.trade.gov/ftz.
For further information, contact Diane Finver at
[email protected] or (202) 482-1367.
Dated: October 22, 2015.
Andrew McGilvray,
Executive Secretary.
[FR Doc. 2015-27620 Filed 10-28-15; 8:45 am]
BILLING CODE 3510-DS-P