[Federal Register Volume 83, Number 158 (Wednesday, August 15, 2018)]
[Notices]
[Pages 40568-40569]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 2018-17466]
-----------------------------------------------------------------------
DEPARTMENT OF JUSTICE
Office of Justice Programs
[OJP (NIJ) Docket No. 1750]
Body Armor Manufacturer Workshop
AGENCY: National Institute of Justice, Justice.
ACTION: Notice.
-----------------------------------------------------------------------
SUMMARY: The National Institute of Justice (NIJ) is hosting a workshop
for body armor manufacturers to provide an overview of draft NIJ
Standard 0101.07, Ballistic Resistance of Body Armor, and draft NIJ
Specification Threat Levels and Associated Ammunition to Test Equipment
Intended to Protect U.S. Law Enforcement Against Handguns and Rifles. A
preliminary outline of how the NIJ Compliance Testing Program (CTP),
which manages conformity assessment of body armor, will begin to phase
out use of NIJ Standard 0101.06 and phase in the use of NIJ Standard
0101.07 in the administration of the program over approximately the
next year will be presented. The impact of the transition on the
Compliant Products List (CPL) and Follow-up Inspection Testing (FIT) of
listed body armor models compliant with NIJ Standard 0101.06 over a
longer period of time will also be discussed.
This will be an open forum and there will opportunities for
attendees to ask questions. Space is limited at this workshop, and as a
result, only 100 participants will be allowed to register. NIJ requests
that each manufacturer limit their representatives to no more than two
per organization. Exceptions to this limit may occur, should space
allow. Participants planning to attend are responsible for their own
travel arrangements. To register for the workshop, please send an email
to [email protected] by 5:00 p.m. Eastern time on September 7, 2018,
and provide the name of your company and the names of the
representatives who will attend. A preliminary agenda will be sent to
registered attendees approximately one week prior to the workshop.
[[Page 40569]]
DATES: The workshop will be held on Wednesday, September 19, 2018 from
8:30 a.m. to 5:00 p.m. Eastern time.
ADDRESSES: The workshop will be held at the Loews Annapolis Hotel, 126
West St., Annapolis, MD 21401.
FOR FURTHER INFORMATION CONTACT: Mark Greene, Policy and Standards
Division Director, Office of Science and Technology, National Institute
of Justice, 810 7th Street NW, Washington, DC 20531; telephone number:
(202) 307-3384; email address: [email protected].
SUPPLEMENTARY INFORMATION: NIJ Standard 0101.07--the proposed revision
of NIJ Standard 0101.06, Ballistic Resistance of Body Armor--specifies
minimum performance requirements and test methods for the ballistic
resistance of body armor used by U.S. law enforcement that is intended
to protect the torso against handgun and rifle ammunition. A request
for public comment was published in the Federal Register on February
22, 2018 (https://www.federalregister.gov/d/2018-03674). The proposed
specification Threat Levels and Associated Ammunition to Test Equipment
Intended to Protect U.S. Law Enforcement Against Handguns and Rifles
defines ballistic threats identified by U.S. law enforcement as
representative of prevalent threats in the United States. A request for
public comment was published in the Federal Register on February 22,
2018 (https://www.federalregister.gov/d/2018-03672).
David B. Muhlhausen,
Director, National Institute of Justice.
[FR Doc. 2018-17466 Filed 8-14-18; 8:45 am]
BILLING CODE 4410-18-P