[Congressional Bills 110th Congress]
[From the U.S. Government Publishing Office]
[H.R. 5214 Introduced in House (IH)]







110th CONGRESS
  2d Session
                                H. R. 5214

    To suspend temporarily the duty on feedthrough with housing 125 
   millimeters long, Housing mounting flange 180 millimeters outside 
                   diameter  x  20 millimeters thick.


_______________________________________________________________________


                    IN THE HOUSE OF REPRESENTATIVES

                            January 29, 2008

Mrs. Tauscher introduced the following bill; which was referred to the 
                      Committee on Ways and Means

_______________________________________________________________________

                                 A BILL


 
    To suspend temporarily the duty on feedthrough with housing 125 
   millimeters long, Housing mounting flange 180 millimeters outside 
                   diameter  x  20 millimeters thick.

    Be it enacted by the Senate and House of Representatives of the 
United States of America in Congress assembled,

SECTION 1. FEEDTHROUGH WITH HOUSING 125 MILLIMETERS LONG, HOUSING 
              MOUNTING FLANGE 180 MILLIMETERS OUTSIDE DIAMETER  x  20 
              MILLIMETERS THICK.

    (a) In General.--Subchapter II of chapter 99 of the Harmonized 
Tariff Schedule of the United States is amended by inserting in 
numerical sequence the following new heading:


``      9902.01.00       Feedthrough with    Free         No change        No change        On or before 12/ ''.
                          housing 125                                                        31/2011.......
                          millimeters long,
                          Housing mounting
                          flange 180
                          millimeters
                          outside diameter
                          x  20 millimeters
                          thick. Housing
                          includes 30
                          millimeters
                          outside diameter
                          shaft of 273
                          millimeters
                          length. Shaft
                          extends 70
                          millimeters from
                          housing face on
                          one end and 78
                          millimeters from
                          housing on
                          opposite end.
                          Unit includes
                          rubber O-ring of
                          5 millimeters
                          thickness and 110
                          millimeters
                          inside diameter;
                          2 stainless steel
                          keystocks of 8
                          millimeters
                          height, 7
                          millimeters width
                          and 30
                          millimeters
                          length; and 8
                          installation
                          screws (provided
                          for in subheading
                          8483.60.80)......

    (b) Effective Date.--The amendment made by subsection (a) applies 
to articles entered, or withdrawn from warehouse for consumption, on or 
after the 15th day after the date of the enactment of this Act.
                                 <all>