[Federal Register Volume 59, Number 7 (Tuesday, January 11, 1994)] [Unknown Section] [Page 0] From the Federal Register Online via the Government Publishing Office [www.gpo.gov] [FR Doc No: 94-344] [[Page Unknown]] [Federal Register: January 11, 1994] ======================================================================= ----------------------------------------------------------------------- DEPARTMENT OF TRANSPORTATION Federal Aviation Administration 14 CFR Part 39 [Docket No. 93-NM-230-AD; Amendment 39-8791; AD 94-01-09] Airworthiness Directives; Canadair Model CL-600-2B19 ``Regional Jet'' Series 100 Airplanes AGENCY: Federal Aviation Administration, DOT. ACTION: Final rule; request for comments. ----------------------------------------------------------------------- SUMMARY: This amendment adopts a new airworthiness directive (AD) that is applicable to Canadair Model CL-600-2B19 ``Regional Jet'' Series 100 airplanes. This action requires a revision to the Airplane Flight Manual (AFM) to limit altitude and airspeed operations of the airplane under certain conditions of hydraulic system failure. This amendment is prompted by a report of sheared-off shear pins found on one airplane's elevator dampers. The actions specified in this AD are intended to prevent undampened vibration of the elevators in normal cruise conditions when combined with hydraulic system failures, a condition which could result in reduced controllability of the airplane. DATES: Effective January 26, 1994. Comments for inclusion in the Rules Docket must be received on or before March 14, 1994. ADDRESSES: Submit comments in triplicate to the Federal Aviation Administration (FAA), Transport Airplane Directorate, ANM-103, Attention: Rules Docket No. 93-NM-230-AD, 1601 Lind Avenue, SW., Renton, Washington 98055-4056. FOR FURTHER INFORMATION CONTACT: Franco Pieri, Aerospace Engineer, Airframe Branch, ANE-172, New York Aircraft Certification Office, FAA, Engine and Propeller Directorate, 181 South Franklin Avenue, room 202, Valley Stream, New York 11581; telephone (516) 791-6221; fax (516) 791- 9024. SUPPLEMENTARY INFORMATION: Transport Canada Aviation, which is the airworthiness authority for Canada, recently notified the FAA that an unsafe condition may exist on certain Canadair Model CL-600-2B19 ``Regional Jet'' Series 100 airplanes. Transport Canada Aviation advises that one operator of these airplanes found that the shear pins on the airplane elevator dampers had sheared off. This finding was made during a routine check of the airplane. The cause of the pin failure has not been determined. Failure of the shear pins on the elevator damper, if not detected and corrected, may lead to undampened vibration of the elevators during normal cruise conditions when combined with hydraulic system failures. This situation could result in reduced controllability of the airplane. This airplane model is manufactured in Canada and is type certificated for operation in the United States under the provisions of Sec. 21.29 of the Federal Aviation Regulations and the applicable bilateral airworthiness agreement. Pursuant to this bilateral airworthiness agreement, Transport Canada Aviation has kept the FAA informed of the situation described above. In order to assure the continued airworthiness of these airplanes in Canada, Transport Canada Aviation issued a Canadian airworthiness directive on December 17, 1993, that restricts operation of these airplanes to certain altitude and airspeed limits under various conditions of hydraulic system failure. The FAA has examined the findings of Transport Canada Aviation, reviewed all available information, and determined that AD action is necessary for products of this type design that are certificated for operation in the United States. Since an unsafe condition has been identified that is likely to exist or develop on other airplanes of the same type design registered in the United States, this AD is being issued to prevent undampened vibration of the elevators during normal cruise conditions in the event of hydraulic system failures, which could result in reduced controllability of the airplane. This AD requires a revision to the Limitations Section of the FAA-approved Airplane Flight Manual (AFM) to restrict altitude and airspeed operations under conditions of single or double hydraulic failure. This is considered interim action until final action is identified, at which time the FAA may consider additional rulemaking. Since a situation exists that requires the immediate adoption of this regulation, it is found that notice and opportunity for prior public comment hereon are impracticable, and that good cause exists for making this amendment effective in less than 30 days. Comments Invited Although this action is in the form of a final rule that involves requirements affecting flight safety and, thus, was not preceded by notice and an opportunity for public comment, comments are invited on this rule. Interested persons are invited to comment on this rule by submitting such written data, views, or arguments as they may desire. Communications shall identify the Rules Docket number and be submitted in triplicate to the address specified under the caption ADDRESSES. All communications received on or before the closing date for comments will be considered, and this rule may be amended in light of the comments received. Factual information that supports the commenter's ideas and suggestions is extremely helpful in evaluating the effectiveness of the AD action and determining whether additional rulemaking action would be needed. Comments are specifically invited on the overall regulatory, economic, environmental, and energy aspects of the rule that might suggest a need to modify the rule. All comments submitted will be available, both before and after the closing date for comments, in the Rules Docket for examination by interested persons. A report that summarizes each FAA-public contact concerned with the substance of this AD will be filed in the Rules Docket. Commenters wishing the FAA to acknowledge receipt of their comments submitted in response to this notice must submit a self-addressed, stamped postcard on which the following statement is made: ``Comments to Docket Number 93-NM-230-AD.'' The postcard will be date stamped and returned to the commenter. The regulations adopted herein will not have substantial direct effects on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, in accordance with Executive Order 12612, it is determined that this final rule does not have sufficient federalism implications to warrant the preparation of a Federalism Assessment. The FAA has determined that this regulation is an emergency regulation that must be issued immediately to correct an unsafe condition in aircraft, and is not a ``significant regulatory action'' under Executive Order 12866. It has been determined further that this action involves an emergency regulation under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979). If it is determined that this emergency regulation otherwise would be significant under DOT Regulatory Policies and Procedures, a final regulatory evaluation will be prepared and placed in the Rules Docket. A copy of it, if filed, may be obtained from the Rules Docket at the location provided under the caption ADDRESSES. List of Subjects in 14 CFR Part 39 Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety. Adoption of the Amendment Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends 14 CFR part 39 of the Federal Aviation Regulations as follows: PART 39--AIRWORTHINESS DIRECTIVES 1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. App. 1354(a), 1421 and 1423; 49 U.S.C. 106(g); and 14 CFR 11.89. Sec. 39.13 [Amended] 2. Section 39.13 is amended by adding the following new airworthiness directive: 94-01-09 Canadair: Amendment 39-8791. Docket 93-NM-230-AD. Applicability: Model CL-600-2B19 ``Regional Jet'' Series 100 airplanes; serial numbers 7003 and subsequent; certificated in any category. Compliance: Required as indicated, unless accomplished previously. To prevent undampened vibration of the elevators during normal cruise conditions in the event of hydraulic system failures, which could result in reduced controllability of the airplane, accomplish the following: (a) Within 30 days after the effective date of this AD, revise the Limitations Section of the FAA-approved Airplane Flight Manual (AFM) to include the following restrictions of altitude and airspeed operations under conditions of single or double hydraulic system failure; and advise the flight crew of these revised limits. Revision of the AFM may be accomplished by inserting a copy of this AD in the AFM. Note 1: The restrictions described in the AFM Temporary Revision (TR) RJ/30 meet the requirements of this paragraph. Therefore, inserting a copy of TR RJ/30 in lieu of this AD in the AFM is considered an acceptable means of compliance with this paragraph. ------------------------------------------------------------------------ Altitude limit (maximum) Airspeed limit (maximum) ------------------------------------------------------------------------ Single Hydraulic System Failure: 31,000 feet....... 0.55 Mach (199 KIAS). 30,000 feet....... 0.55 Mach (204 KIAS). 28,000 feet....... 0.55 Mach (213 KIAS). 26,000 feet....... 0.55 Mach (222 KIAS). 24,000 feet....... 0.55 Mach (232 KIAS). 22,000 feet....... 0.55 Mach (241 KIAS). 20,000 feet and 252 KIAS. below. Double Hydraulic System Failure: 10,000 feet....... 200 KIAS. ------------------------------------------------------------------------ (b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, New York Aircraft Certification Office (ACO), FAA, Engine and Propeller Directorate. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, New York ACO. Note 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the New York ACO. (c) Special flight permits may be issued in accordance with FAR 21.197 and 21.199 to operate the airplane to a location where the requirements of this AD can be accomplished. (d) This amendment becomes effective on January 26, 1994. Issued in Renton, Washington, on January 3, 1994. Darrell M. Pederson, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. 94-344 Filed 1-10-94; 8:45 am] BILLING CODE 4910-13-U