[Federal Register Volume 62, Number 22 (Monday, February 3, 1997)]
[Corrections]
[Page 5074]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: X97-10203]



Federal Register / Vol. 62, No. 22 / Monday, February 3, 1997 / 
Corrections

[[Page 5074]]


-----------------------------------------------------------------------

ENVIRONMENTAL PROTECTION AGENCY

40 CFR Part 63

[AD-FRL-5664-8]
RIN 2060-AE-86


National Emission Standards for Hazardous Air Pollutants for 
Flexible Polyurethane Foam Production

Correction

    In proposed rule document 96-32237 beginning on page 68406 in the 
issue of Friday, December 27, 1996, make the following corrections:


Sec. 63.1292  [Corrected]

    1. On page 68419, in the first column, in Sec. 63.1292, in the 25th 
line from the bottom, ``Hap'' should read ``HAP''.
    2. On the same page, in the second column, in the same section, in 
the sixth line from the bottom, the first ``absorbers'' should read 
``adsorbers''.


Sec. 63.1296  [Corrected]

    3. On page 68420, in the second column, in 
Sec. 63.1296(a)(2)(iii)(B), in the last line, ``applicable'' should 
read ``practicable''.


Sec. 63.1300  [Corrected]

    4. On page 68424, in the first column, in Sec. 63.1300(b), in the 
third line, before ``foam'' insert ``polyurethane''.


Sec. 63.1303  [Corrected]

    5. On the same page, in the second column, in 
Sec. 63.1303(b)(1)(i), in the fifth line, ``and'' should read 
``through''.


Sec. 63.1307  [Corrected]

    6. On page 68428, in the second column, under 
Sec. 63.1307(c)(2)(v), paragraphs (vi), (vii) and (d) were 
inadvertently removed and should read as follows:
    ``(vi) Records of all calibrations for each device used to measure 
the amount of HAP ABA in the storage vessel, conducted in accordance 
with Sec. 63.1303(d)(3).
    (vii) Records to verify that all scales used to measure the amount 
of HAP ABA added to the storage vessel meet the requirements of 
Sec. 63.1303(e)(2). For scales meeting the criteria of 
Sec. 63.1303(e)(2)(i), this documentation shall be in the form of 
written confirmation of the State or local approval. For scales meeting 
the criteria of Sec. 63.1303(e)(2)(ii), this documentation shall be in 
the form of a report provided by the registered scale technician.
    (d) Records for sources with enforceable emission limitations below 
major source levels. Processes exempted from this subpart through a 
federally enforceable emission limitation in accordance with 
Sec. 63.1290(b)(1), and that have notified the Administrator of this 
self-imposed limitation through Sec. 63.1306(c)(9), shall maintain 
records to support the emission estimates provided in the annual 
emission reports, submitted in accordance with Sec. 63.1306(f)(3). 
These emission estimates may be based on inventory records, material 
balance calculations, emission tests, or other engineering analyses.''
BILLING CODE 1505-01-D